Aaron McKenzie | Mold A

Design I

This will hopefully be a radial tentacle thing

Part

Bottom Mold

Top Mold

note: these are sldprt files because WordPress didn’t allow stl upload

referenced files

Design II

Results

A jig was made to simplify the bonding process
completed part
The part unfortunately did not inflate due to fractures caused during demolding. When the hole was manually plugged, the pockets inflated but the part did not flex as intended. This is most likely due to the material stiffness of the silicone. The part should be remade using ecoflex 00-31 or 00-45

Leave a Reply