Elegoo Super Starter Kit¶
The Fall 2020 course kit includes an Elegoo Super Starter Kit with an Arduino Uno and many components. This was an efficient way to provide an Arduino along with a broad selection of interface components. Not all parts are standard lab stock, and many are not used in the course exercises.
Please note that Elegoo provides a large downloadable package with datasheets and a tutorial guide which may be a useful companion resource. You may find the current version under “Super Starter Kit” on https://www.elegoo.com/download/
Elegoo Kit Inventory¶
Quantity |
Description |
Notes |
|---|---|---|
1 |
ELEGOO UNO R3 Controller Board (Arduino-Compatible) |
|
1 |
USB Cable |
|
1 |
9V Battery with DC |
|
1 |
Power Supply Module |
|
1 |
Breadboard, 830 tie points |
|
1 |
Breadboard Expansion Board |
shield with hole patterns and small solderless breadboard |
1 |
65 Jumper Wire |
male to male |
10 |
Female-to-male DuPont Wire |
|
Sensors and User Input |
||
5 |
Button (small) |
|
1 |
Tilt Ball Switch |
|
1 |
10K Potentiometer |
knob must be assembled to body; body takes a lot of pressure to seat in breadboard |
2 |
Photo resistor |
|
1 |
Joystick Module |
|
1 |
Ultrasonic Sensor |
|
1 |
Thermistor |
|
1 |
DHT11 Temperature and Humidity Module |
single-wire serial bus |
1 |
Remote |
|
1 |
IR Receiver |
|
Actuators and Sound |
||
1 |
Servo Motor (SG90) |
brown is ground, red is power, orange is control |
1 |
Stepper Motor |
|
1 |
Fan Blade and 3-6V Motor |
|
1 |
ULN2003 Stepper Motor Driver Board |
four single-ended outputs |
1 |
Active Buzzer |
3.5 to 5V, ~2300 Hz; DC power produces sound |
1 |
Passive Buzzer |
3 to 12V, 16 ohm; a small speaker, needs a waveform |
Displays and Lighting |
||
1 |
LCD1602 Module (with pin header) |
16x2 character display, parallel bus |
1 |
1 digit 7-segment Display |
|
1 |
4 digit 7-segment Display |
|
5 |
Yellow LED |
|
5 |
Blue LED |
|
5 |
Green LED |
|
5 |
Red LED |
|
2 |
RGB LED |
|
Electronic Components |
||
120 |
Resistors, assorted |
values (quantities): 10 ohm (10), 100 ohm (10), 220 ohm (30), 330 ohm (10), 1K (10), 2K (10), 5.1K (10), 10K (10), 100K (10), 1M (10) |
2 |
Diode Rectifier (1N4007) |
|
1 |
5V Relay |
|
2 |
NPN Transistor (PN2222) |
|
1 |
IC 74HC595 |
8-bit serial-in, serial or parallel-out shift register; useful for I/O extension |
1 |
L293D |
quad half-H bridge driver, useful for driving two small DC motors |
Elegoo Visual Guide¶
