Page 7 of 9
For the second demo, I decided to laser cut a new object to integrate a photointerruptor. The new object looks like a vertically flipped Omega symbol, which oscillates…
For the second demo, I wanted to create a small pinball machine with two switches to control two servos that act as “flaps” Brainstorming For brainstorming, I drew…
Ideation For this project, I wanted to use a circular motion to trigger a photoreceptor as a proximity sensor to a surface. Originally, I intended to make a…
Videos Description My project for Demo 2 is a rocker that moves two balls back and forth, using a photoreflector to sense the ball bearing’s location to know…
I used a switch to receive info about where my rocker was. I put the switch in the center so that when the toy moves through the center,…
For this first demo, I expected the general products to be very similar to the example shown in class. I felt that the real lack of structure and…
The preferred mode for posting Arduino code is to use a SyntaxHighlighter Code block type, setting the “Code Language” to “C / C++” in the properties (on the…
Here’s a demo of my execution of “Rocking and Rolling”: Brainstorming and Initial Ideas Initially, I wanted to create rocking motion that could move a ball bearing from…
My project was originally intended to make the bottom pieces perform a circular motion. However, it did not work out with only the one servo and I decided…
With some previous experience in Solidworks, I decided to make a system which used the servo motor to rotate anything attached to it. I laser cut attachable wooden…