Page 2 of 8
The last week has been about setting up the electronics and assembling things into the suitcase. We laser cut the acrylic covering for our main components as well…
Ebrahim Karam & Evangeline there is a reading every 5 seconds from an ultrasound sensor to see if someone is there. If the person leaves for 50 seconds….
Scare-case photo
Ebrahim Karam & Evangeline Self-promotion Picture A collage of the two The centerpiece was actually too small and so I resized it to be 75% of the first…
We iterated the experience design to make the journey of the guest more surprising by adding sensor driven lights and movements. Documenting the journey map, storyboard and experience…
what have we done since last progress report: we created a prototype for our conveyor belt which has two platforms to hold the motor together and using a…
Over the last week, we made some important decisions regarding the wind motions we are going to achieve. We also progressed quite a bit with CAD designs, and…
Scare-case The Sensors: Progress: Tested out usage of the PIR motion sensor and ultrasonic sensor by hooking it up to the Raspberry Pico. The ultrasonic sensor works using…
This week, while not much physical prototyping has been done, we’ve narrowed down the scope of our final project in both code and CAD. The cuttlefish controller will…
We now have 12 frames per revolution. We also got the setup to be phase-dependent instead of time-dependent. This removes the sliding effect we had before. This means…