Month: September 2019Page 5 of 6
The preferred mode for posting Arduino code is to use a SyntaxHighlighter Code block type, setting the “Code Language” to “C / C++” in the properties (on the…
Here’s a demo of my execution of “Rocking and Rolling”: Brainstorming and Initial Ideas Initially, I wanted to create rocking motion that could move a ball bearing from…
My project was originally intended to make the bottom pieces perform a circular motion. However, it did not work out with only the one servo and I decided…
With some previous experience in Solidworks, I decided to make a system which used the servo motor to rotate anything attached to it. I laser cut attachable wooden…
This device was inspired by John Edmark’s kinetic spiral art and the Fin Ray Effect, a structure used in robotic soft grippers. When given this assignment, I immediately…
Brainstorming With no experience in SolidWorks, I decided to only modify the project a little, by reducing the inner radius by half. I was curious on how to…
My project mimics those toys that never fall over no matter how hard you push them. The trick is to put their center of gravity low and centered…
Swinger Meant to mimic “pirate ship rides” at amusement parks, this project shows a simple phenomena: despite the large swinging motion of the servo, the ball stays in…
Project Objectives The main objective was to produce a physical mechanism that produces a pattern of motion over time. My project rocks back and forth at increasingly steeper…
This is a simple mechanism that allows the ball move along a random path and finally falls into a hole. The angle of the swing is randomized so…