Zortrax M200: Printing Platform

Remove

Removing the Print Platform

WARNING: HEAT HAZARD
Before removing the print platform, switch the equipment OFF, and unplug the power cable.
Unplug the heatbed cable from the platform. Both big and small connectors need to be unplugged.
Remove the platform by lifting UP and guiding out.

Clean

Cleaning the Print Platform

WARNING: CUTTING HAZARD

Put on the RUBBER GLOVES included in the Zortrax M200 Kit. The kit also includes a sharp-edge spatula. Place the platform onto a secure/steady table-top. With one hand holding the platform in an upright position, (gently) guide the spatula across the platform and AWAY from your body and hand. Remove as much material as possible.

*NOTE: Please notify IDeATe Technical Staff if there is any permanent residue you are unable to remove. DO NOT replace the platform unless it is clean and prepared for the next user.

Replace

Replacing the Print Platform
Open the front panel, put the platform back in the printer and plug the heatbed cable in. Both big and small connectors need to be plugged in.
Plug the power cable in. Turn ON the printer and wait until the plate heats up. Notify IDeATe Technical Staff of any issues when returning your M200 Kit.