Zortrax M200: Printing Platform

	Removing the Print Platform
	WARNING: HEAT HAZARD
	Video Player Error loading this resource 00:00 00:00 00:00 Use Up/Down Arrow keys to increase or decrease volume.

	Before removing the print platform, switch the equipment OFF, and unplug the power cable.

	Video Player Error loading this resource 00:00 00:00 00:00 Use Up/Down Arrow keys to increase or decrease volume.

	Unplug the heatbed cable from the platform. Both big and small connectors need to be unplugged.

	Video Player Error loading this resource 00:00 00:00 00:00 Use Up/Down Arrow keys to increase or decrease volume.

	Remove the platform by lifting UP and guiding out.

	Cleaning the Print Platform
	WARNING: CUTTING HAZARD
	Video Player Error loading this resource 00:00 00:00 00:00

	Put on the RUBBER GLOVES included in the Zortrax M200 Kit. The kit also includes a sharp-edge spatula. Place the platform onto a secure/steady table-top. With one hand holding the platform in an upright position, (gently) guide the spatula across the platform and AWAY from your body and hand. Remove as much material as possible. *NOTE: Please notify IDeATe Technical Staff if there is any permanent residue you are unable to remove. DO NOT replace the platform unless it is clean and prepared for the next user.

	Replacing the Print Platform

	Video Player Error loading this resource 00:00 00:00 00:00

	Open the front panel, put the platform back in the printer and plug the heatbed cable in. Both big and small connectors need to be plugged in.

	Video Player Error loading this resource 00:00 00:00 00:00

	Plug the power cable in. Turn ON the printer and wait until the plate heats up. Notify IDeATe Technical Staff of any issues when returning your M200 Kit.

Remove